PSC Magellan 8500 Spécifications télécharger pdf (Page 108)

5-6 Magellan

8500Xt Scanner

9. When the scale is ready, the Yellow LED will begin blinking again

and the display will show the message “Ad20 (add twenty

pounds)” or “Ad10 (add ten kilograms).” The scanner/scale will

also sound one tone if the scale is weighing in kilograms or two

tones for pounds. Place the correct weight (twenty pounds for cal-

ibration in pounds, or ten kilograms for metric calibration) from

the F

ield Standard Weight set on the center of the weighing area

and press the Zero Push Button again.

10. The Yellow LED will extinguish for approximately 10 seconds

and the R

emote Display will alternately display

and

until the scale is ready to proceed.

11. If the calibration was successful, t

he speaker sounds a single tone,

the Scale Status LED begins blinking again, and “End-” appears

in the Remote Display.

12. If the calibration was not successf

ul, the speaker will sound five

tones indicating a scale failure, and the Scale Status LED will

blink twice, strobe (fast blinks) and then continually repeat this

sequence until reset. Remove all weight from the Weigh Platter,

and repeat the procedure starting with step

13. Press the Zero Push Button again to permanently store the cali-

bration data and exit Calibration Mode. You have completed the

calibration of the scanner/s

cale. The unit’s calibration must now

be verified as required by state and/or local weights and measures

regulations. The verification procedure must be performed to

assure that a scale will pass Weights and Measures requirements

before it is placed into commercial/retail service.

You have completed the scale calibration procedure. You must now con-

tinue with the calibration verification tests to complete the scale’s calibra-

tion. If you are weighing in pounds, continue with the following

ocedures to verify that the scale was successfully calibrated and that it

weighs properly. If you are weighing in kilograms, turn to the instructions

titled,

Calibration Verification (Kilograms), later in this section.

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 479 480

Pas de commentaire

PSC Magellan 8500 Spécifications Page 108