PSC Magellan 8500 Spécifications télécharger pdf (Page 217)

100

101

Product Reference Guide 7-79

Global Prefix

This feature applies to RS-232 interfaces (Standard, Wincor-Nixdorf, and

Single Cable). It specifies the prefix that is added to beginning of label

transmission.

To specify the Global Prefix Character(s):

1. Scan the SWITCH barcode.

2. Scan the barcode, SET GLOBAL PREFIX below. You’ll need to

cover any unused barcodes to ensure the scanner reads only the

barcod

e you intend to scan.

3. Scan the appropriate characters/digits from the keypad

in Appen-

dix C that represent the hex designation for the desired charac-

ter(s). A table containing the ASCII Character Set and their

corresponding Hex Values is available in the inside back cover of

this

manual. ASCII parameters must be input by scanning a pair

of hexadecimal digits for each character. Thus, to set a two-char-

acter value of AB, barcodes containing

the digits ‘4’, ‘1’, ‘4’, and

‘2’ must be scanned. The selectable range for this option is any

hex value from 00 to FF. Up to 20 hex pairs can be designated.

NOTE

To specify “no Global Prefix,” scan 00.

4. If designating the full 20 hex pairs, the scanner will automatically

exit Programming Mode when the appropriate amount of digits

have been scanned. If designating less than 20 hex pairs, you can

end the programming sequence early by scanning the TERMI-

NATE SEQUENCE barcode.

5. Complete the programming sequence by scan

ning the SWITCH

barcode.

1 2 ... 212 213 214 215 216 217 218 219 220 221 222 ... 479 480

Commentaires sur ces manuels

Pas de commentaire

PSC Magellan 8500 Spécifications Page 217

Commentaires sur ces manuels

Produits connexes et manuels pour Lecteurs de codes-barres PSC Magellan 8500