PSC Magellan 8500 Spécifications télécharger pdf (Page 77)

Product Reference Guide 3-7

Error Reporting

If a fatal error is detected during Selftest or operation, the unit will not

advance to Normal Operation Mode. Selftest diagnostics will cause the

unit to sound a long, low tone and/or display an error message on the 7-

segment display indicating where the failure occurred. These messages are

coded to assist the repair technician in identifying the failed component.

If the error is with the EAS deactivation system, the bottom-most LED

will flash red. If an error is indicated, make note of it and contact your

supervisor or technical support representative. A table containing descrip-

tions of these error codes is included in

Chapter 4, Problem Isolation.

If a non-fatal

error is detected (such as the loss of one of the two lasers, or

EAS deactivation system error), the unit will sound a long, low tone and

display

a number on the 7-segment display. The unit will advance to Nor-

mal Operating Mode, but performance may be

affected until a correction

or repair is made.

Operational Configuration

Once Selftest diagnostics have been successfully run, a tone is emitted (if

configured to do so, and the unit enters an operational configuration state.

The scanner or scanner/scale will automatically load your specific interface

settings which are required to communicate with the host system. There

are two conditions that must be met before the unit can enter Operating

Mode:

• No barcode label can be in the scan volume while the unit is in

this

state. Progress is halted until the label has been removed,

thereby ensuring that no extraneous barcode data is send to the

host.

• If your scanner has a scale, the scale cannot be in motion (usually

caused

by excessive vibration in the checkstand) for this test to

succeed. A “Scale in Motion” status will be indicated by display-

ing a period and the applicable w

eight unit (lb

. lb

. kg

) that is selected.

• The scale must be able to “capture” zero weight. The

display will be seen if there is a weight on the platter

1. Scanner behavior under non-fatal error conditions is configurable. See Chapter 7, Pro-

gramming

for more details.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 479 480

Commentaires sur ces manuels

Pas de commentaire

PSC Magellan 8500 Spécifications Page 77

Commentaires sur ces manuels

Produits connexes et manuels pour Lecteurs de codes-barres PSC Magellan 8500